WD-40 Drying Contact Cleaner spray is a non-conductive spray that is suitable for use on all sensitive electrical components. It provides excellent cleaning with minimal fuss, and removes dirt, dust, condensation and flux residue with ease.
Simply spray on and allow the product to dry before powering up. Our fast-drying electrical contact cleaner spray is ideal for use on circuit boards, switches, even spark plugs and tape heads. It will remove all the contaminants that cause current leakage and component failure.You can safely use Fast Drying Contact Cleaner on plastics, rubber and metal for superior cleaning.
FEATURES & BENEFITS
• Cleans Sensitive Electronic Equipment
• Leaves No Residue
• Plastic & Metal Safe
• Dielectric Strength > 25,000 Volts
• 50-state VOC Compliant
• Quick Drying
• NSF K2 Reg# 146857
APPLICATIONS
• Printed Circuit Boards
• Controls
• Switches
• Tape Heads
• Precision Instruments
DIRECTIONS OF USE
Shut off all power and allow any hot surfaces to cool. Make sure all stored power is drained from the system. Shake Can Well. Flip straw up for pinpoint STREAM or down for wide angle SPRAY. Hold can 6 to 8 inches away from the surface and spray directly on to the electronic device or circuit board to eliminate and remove any contaminants that may cause loss of electrical contact. Tilt surface while cleaning and allow any excess cleaner to run off. Allow product to dry completely and thoroughly vent the system before restoring power.
