FBN II ZP Bolt Anchor-12/100

The Fischer bolt anchor FBN II is a steel anchor for cost-effective fixations in non-cracked concrete. Thanks to its long thread and the two anchorage depths, the Fischer bolt anchor FBN II is particularly flexible. In addition to pre-positioned and push-through installation, the bolt anchor is suitable for stand-off installation. In the stainless steel design, the bolt anchor is suitable for facade sub-structures, cantilevers, and ladders outside.

Technical Data:

12/100

• ETA-approval: Yes
• Drill diameter d0: 12 [mm]
• Min. drill hole depth for through fixings h2: 185 [mm]
• Anchor length l: 194 [mm]
• Max. usable length hef,max./hef,min. tfix: 100 / 115 [mm]
• Thread Ø x length: M12 x 149 [mm]
• Width across nut: 19 [mm]
• Packaging: Folding box

Advantages

• The standard anchorage depth achieves the maximum load-bearing capacities. Thus fewer fixing points and smaller anchor plates are required.
• The reduced anchorage depth reduces the drill hole depth. This minimizes the amount of time needed for installation whilst increasing flexibility.
• The long thread balances component tolerances and allows for stand-off installations, thus increasing flexibility.
• Few hammer blows and the minimal torque slippage allow for a noticeably simpler installation.
• The drive-in pin protects the thread from damage, and thus ensures a faster installation and dismantling of the attachment.